Brake Light Switch: Adjustments

STOP LAMP SWITCH ADJUSTMENT

NOTE: Proper stop lamp switch adjustment is essential. Improper stop lamp switch adjustment may cause brake drag, heat buildup and excessive brake lining wear.




1. Disconnect stop lamp switch electrical connectors.
2. Rotate stop lamp switch counter-clockwise and remove stop lamp switch from stop lamp switch retainer.

IMPORTANT:
^ Do not depress brake pedal assembly during stop lamp switch installation. Depressing brake pedal will cause a brake drag condition.
^ Adjust stop lamp switch and cruise brake switch at the same time.




3. Install stop lamp switch.
3.1 Position switch into retainer with electrical connectors pointing to the 1 o'clock position.
3.2 Slide switch in retainer until plunger is fully depressed into barrel.
3.3 Rotate switch clockwise until travel stop has been reached (approximately 600).
3.4 Inspect stop lamp switch to insure switch is properly locked into stop lamp switch retainer with stop lamp switch electrical connectors pointing to the 3 o'clock position.




4. Connect stop lamp switch electrical connectors.
5. Inspect stop lamps for proper operation.