Control Cable Bracket Assembly

CONTROL CABLE BRACKET ASSEMBLY

REMOVAL

CAUTION: DO NOT TIP BATTERY OVER 45° ANGLE OR ACID COULD SPILL.

IMPORTANT: Record all pre-set radio stations.

1. Remove battery.
1.1. Remove battery cover.
1.2. Disconnect negative battery cable.
1.3. Disconnect positive battery cable.
1.4. Loosen battery hold-down screw and remove battery.
2. Remove battery cooling box.
3. Remove battery tray bracket.
3.1. Loosen battery tray bracket screws and remove bracket.





NOTICE: The control cable must be disconnected from the transaxle range switch lever prior to disconnecting it from the control cable bracket. Otherwise damage to the manual shift shaft may result, requiring transaxle disassembly.

4. Disconnect control cable from transaxle range switch lever.
(VT25-E Shown)





5. Depress control cable retainer clip tabs and remove cable from control cable bracket.
(AF33-5 shown)





6. Remove control cable bracket.
(AF33-5 Shown)

INSTALLATION





1. Install control cable bracket.
(VT25-E Shown)
Torque: Control Cable Bracket Bolts: 23 Nm (17 ft. lbs.)
2. Route control cable through cable bracket.





(VT25-E Shown)





3. Secure cable to bracket with control cable retainer clip. An audible snap will be heard when properly installed.
(AF33-5 shown)
4. Snap cable end fitting onto ball stud of transaxle range switch ]ever.





5. Install battery tray bracket.
5.1. Position battery tray bracket and tighten screws.
Torque: Battery Tray Bracket Screws: 16 Nm (12 ft. lbs.)
6. Install battery cooling box.





7. Install battery.
7.1. Insert battery and tighten battery hold-down screw.
Torque: Battery Hold-Down Screw: 15 Nm (11 ft. lbs.)
7.2. Connect positive battery cable to battery.
Torque: Battery Terminal Bolts: 17 Nm (13 ft. lbs.)
7.3. Connect negative battery cable to battery.
Torque: Battery Terminal Bolts: 17 Nm (13 ft. lbs.)
7.4. Install battery cooling box cover and tighten screws.
Torque: Battery Cooling Box Cover Screws: 2 Nm (1.5 ft. lbs.)
7.5. Reprogram radio stations.