Radio Replacement

REMOVAL




1. Partially remove center trim panel by pulling trim panel at clip locations to disengage clips. Clips (6) are integral to trim panel. Slightly rotate trim panel to access back of panel.




2. Disconnect hazard switch connector.
3. Disconnect dimming control connector.
4. Disconnect traction control switch.
5. Disconnect foglamp switch connector.




6. Disconnect HVAC control electrical connectors.




7. Disconnect HVAC cable from HVAC control.
8. Place center trim panel aside.




9. Remove (2) fasteners securing radio.




10. While providing support, partially remove radio to obtain access to back of radio.
11. Disconnect 24-way radio connector.
12. Disconnect 12-way radio connector, if equipped.
13. Disconnect antenna connector.




14. Disconnect ground strap blade connector.
15. Radio can now be removed.

INSTALLATION




1. While providing support to radio, connect ground strap to tab at back of radio.




2. Connect antenna lead to radio.
3. Connect 24-way connector to radio.
4. Connect 12-way connector to radio, if equipped.




5. Position radio over 2 locating pins in I/P retainer. Insure proper harness routing.
6. Install radio to I/P retainer with 2 fasteners.

Torque:
Radio Fasteners
All Except AM/FM Stereo Cassette with 6-Disc In-Dash CD Player: 2 N.m (18 in-lbs)
AM/FM Stereo Cassette with 6-Disc In-Dash CD Player: 2.5 N.m (22 in-lbs)




7. Position center trim panel to allow for connection of switches and controls.
8. Connect HVAC cable using control synchronization procedure.




9. Connect HVAC control electrical connectors.




10. Connect fog lamp switch connector.
11. Connect traction control switch connector.
12. Connect dimming control connector.
13. Connect hazard switch connector.




14. Install center trim panel I/P retainer. Insure proper harness routing.