Radio Trim Bezel

REMOVAL




1. Move shifter to neutral position.
2. Pull up at rear edge of horseshoe bezel first disengaging retention clips, up over shifter assy, then down and back at front to gain access to underside switch connection.




3. Disconnect the following.
^ Window switches
^ Mirror switch
^ Cigar lighter
4. Remove horseshoe bezel.




5. Remove lower I/P front console storage compartment to I/P retainer screws upper storage compartment to radio bezel screws and I/P console storage compartment.




6. Pull lower edge of radio bezel rearward disengaging lower clips then upper portion rearward disengaging upper clips.




7. Disconnect HVAC controller.
^ Temperature cable
^ Blower switch
^ 20-way connector




8. Disconnect the following:
^ Airbag telltale
^ Foglamp switch
^ Dimmer switch/TCS
^ Hazard switch




9. Remove HVAC controller to Radio Bezel screws and controller.

SWITCH REMOVAL
1. Using a small flat bladed screwdriver depress retention tabs of Hazard switch and remove switch.
2. Using a small flat bladed screwdriver depress retention tabs of Dimmer switch remove switch.
3. If equipped, using a small flat bladed screwdriver depress retention tabs of Foglamp switch/TCS and remove Foglamp switch/TCS.
4. Using a small flat bladed screwdriver depress retention tabs of airbag telltale and remove telltale.

SWITCH INSTALL
1. Position airbag telltale to bezel housing and snap into place.
2. Position dimmer switch to bezel housing and snap into place.
3. Position hazard switch to bezel housing and snap into place.
4. If equipped, position foglamp switch to bezel housing and snap into place.

INSTALLATION




1. Install HVAC Controller to Radio Bezel with screws.




2. Center temperature cable knob by inserting assembly alignment tab into centering slot of temperature know shaft




3. Center HVAC module temperature door by aligning cable lug of temperature control cable with center point of detent spring (detent spring force should hold temperature door in desired position for assembly).




4. Install temperature cable to HVAC controller by aligning retention tabs and temperature knob shaft and snapping into place.
5. Connect I/P harness to blower switch and HVAC controller.
6. Connect I/P harness to HVAC controller.




7. Connect I/P harness to.
^ Airbag telltale
^ Foglamp switch
^ Dimmer switch
^ Hazard switch




8. Install radio bezel by inserting upper front edge clips first, sliding bezel forward while holding down on front edge of bezel to engage upper retention clips then pressing forward at lower clip location engaging lower clips.




9. Install I/P front console storage compartment and screws.




10. Connect wire harness to window switches, mirror switch and cigar lighter.
11. Move shifter to neutral position.




12. Install front edge of horseshoe bezel first over shift assembly making sure to engage alignment pins and front edge tabs with corresponding slots a bottom of radio bezel, clear wires and lower back edge snapping into place by pressing down.
13. Put shifter in PARK position.