Instrument Panel (IP) - Endcap Replacement - Left

REMOVAL




1. Remove screws and gently pull rearward at clip locations to remove I/P filler panel (knee bolster).




2. Remove left end panel by pulling outward at rear edge to disengage retention clips and then rearward from I/P.




3. Disconnect I/P harness from doorjamb switch and remove end panel.

INSTALLATION

1. Connect I/P harness to door jamb switch and install left end panel by inserting tabs at back of panel with corresponding slots in I/P and snapping into place by applying light force at clip locations.




2. Install I/P filler panel (knee bolster) by aligning retention tabs on panel with corresponding slots in retainer and pressing forward at clip locations to snap into place.
3. Install filler panel to retainer screws.