Instrument Panel (IP) - Endcap Replacement - Right

REMOVAL




1. Open I/P compartment door.
2. Remove end panel to retainer push pins.
3. Pull outboard at clip locations to disengage clips then rearward to disengage end panel tabs to retainer.
4. Disconnect door jamb switch.

INSTALLATION




1. Connect I/P harness to door jamb switch and install right end panel by inserting tabs at back of panel with corresponding slots in I/P and snapping into place by applying light force at clip locations.
2. Install end panel to retainer push pins.
3. Close I/P compartment.