Seat Replacement - Front Bucket

Front Seat Replacement - Bucket

Removal Procedure






1. Position the seat fully forward.
2. Disconnect the shoulder belt from the seat quick disconnect feature by using a flat-bladed tool to press the tab.






3. Remove the front seat adjuster bolts.
4. Move the seat to the full rearward position.






5. Disconnect the seat electrical connectors.
6. Lift the front seat adjuster hooks from the floor pan.
7. Remove the seat from the vehicle.

Installation Procedure






Important: This step must be performed to assure proper timing of the adjusters.

1. Adjust the seat adjuster tracks to the fully rearward position.
2. Position the seat in the vehicle and engage the front adjuster hooks in the floor pan.






3. Position the seat in the fully forward position to expose the rear bolt locations.
4. Connect the seat electrical connectors.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.






5. Install the seat adjuster bolts. Tighten the bolts to 50 Nm (37 lb ft).
6. Install the shoulder belt webbing in the quick disconnect anchor.
7. Inspect the front seat belt for proper operation.