Transmission Position Sensor/Switch: Adjustments

ADJUSTMENT PROCEDURE
1. Shift transaxle into (N) Neutral position.





2. Using Fascia Retainer Remover J36346 remove control cable assembly from transaxle range switch lever.





3. Remove transaxle range switch lever nut and lever.
4. Loosen transaxle range switch bolts.





5. Insert transaxle range switch tool J44810 as shown and rotate switch until tool drops into position. The switch is aligned when the pin on tool drops into the hole on transaxle range switch.
6. Tighten transaxle range switch bolts.
Torque: Transaxle Range Switch Bolts: 11 N.m (8 ft. lbs.)
7. Remove alignment tool.





8. Install transaxle range switch lever and nut.
Torque: Transaxle Range Switch Lever Nut: 16 N.m (12 ft. lbs.)





9. Install control cable assembly to transaxle range switch lever.
10. After adjusting switch, verify engine only starts in (P) Park or (N) Neutral. If engine starts in any other position, readjust switch.