Control Module: Service and Repair

TRANSAXLE CONTROL MODULE (TCM)

REMOVAL
1. Turn ignition Off.
2. Disconnect JI and J2 transaxle control module electrical connectors.





3. Pull retaining tang from the transaxle control module and rotate the transaxle control module up. Remove the transaxle control module from transaxle control module bracket.

INSTALLATION
1. Install transaxle control module.
2. Connect JI and J2 transaxle control module electrical connectors.

IMPORTANT: DTC P0602 is set with all service transaxle control modules. When the transaxle control module is reprogrammed with the correct software and calibrations, DTC P0602 will be erased.

3. Reprogram the transaxle control module with the correct calibration. Programming and Relearning