Lower Control Arm - Spring Jounce Bumper

Jounce Bumper Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.





2. Remove the jounce bumper nut at the lower control arm.





3. Remove the coil spring. Refer to Coil Spring Insulators Replacement
4. Remove the jounce bumper.

Installation Procedure

1. Install the jounce bumper to the lower control arm.
2. Hand tighten the jounce bumper nut.





3. Install the coil Spring. Refer to Coil Spring Insulators Replacement.

Notice: Refer to Fastener Notice in the Preface section.





4. Tighten the jounce bumper to lower control arm nut.

Tighten
Tighten the nut to 63 N.m (46 lb ft).

5. Lower the vehicle.
6. Check the rear alignment. Refer to Wheel Alignment Measurement in Wheel Alignment.