1. Control Valve Body Assembly Installation

CONTROL VALVE BODY ASSEMBLY INSTALLATION





1. Install spacer plate assembly on transaxle case assembly.
2. Install control valve body assembly on transaxle case assembly.





3. Secure control valve body assembly to transaxle case assembly with 3 silver bolts. Tighten in sequence shown.
Torque: Valve Body Assembly Bolts: 8 N.m (71 inch lbs.)





4. Secure control valve body assembly to transaxle case assembly with 15 black bolts.
^ Tighten the black bolts in three separate steps in the sequence shown.
First step - Tighten to 5 N.m (44 inch lbs.)
Second step - Tighten to 10 N.m (89 inch lbs.)
Third step - Tighten to 14 N.m (14 ft. lbs.)





IMPORTANT: Note the orientation of manual valve before connecting manual valve link assembly.

5. Connect manual valve link assembly to manual valve.





6. Install manual shaft detent assembly and bolt on the control valve body assembly.
Torque: Manual Shaft Detent Assembly Bolts: 11 N.m (8 ft. lbs.)





7. Connect the connector for the input and output speed sensor assembly to the control valve body assembly. Slide the grey locking clip in order to lock connector in place.