Operation CHARM: Car repair manuals for everyone.

P0705

Diagnostic Chart Part 1:




Diagnostic Chart Part 2:




Diagnostic Chart Part 3:




Diagnostic Chart Part 4:




Diagnostic Chart Part 5:




Schematic:




The transaxle range switch is a part of the Park/Neutral position switch assembly. The transaxle range switch determines which gear position has been manually selected. The transaxle control module (TCM) determines this gear selection by detecting a combination of opens and voltages at the four switch inputs of the transaxle range switch. When the switch is open the TCM input is low. When a switch is closed, the TCM input is high. The specific combinations of lows and highs for the four inputs at the TCM denote which gear position has been selected. Only one combination is possible for each manual gear selected. DTC P0705 sets when the TCM input combination is not valid.

DTC PARAMETERS
DTC P0705 will set if the TCM has detected an invalid input combination when:
^ The engine is running
^ Ignition voltage is between 9 and 16 volts.
^ Condition exists for longer than 5 seconds.

DTC P0705 diagnostic runs continuously when the above conditions have been met

The TCM will command Trans. Protection Mode is ON, and allow only 5th gear and reverse, if this DTC is active.

DTC P0705 is a type A DTC.

DIAGNOSTIC AIDS




DTC P0705 can not be set due to a misadjusted shift cable or Park/Neutral Switch Assembly.