Pressure Bleeding Procedure

BRAKE PRESSURE BLEEDING

^ TOOLS REQUIRED
- J29532 Pressure Bleeder
- J44894 Brake Bleeder Adapter

NOTICE: Use only DOT 3 brake fluid from a clean, sealed container. Do not use any fluid from a container which is wet with water. Do not use DOT 5 silicone fluid.

NOTICE: Pressure bleeding equipment must be of the diaphragm type. It must have a rubber diaphragm between the air supply and the brake fluid to prevent air, moisture, and other contaminants from entering the hydraulic system.

1. Clean brake fluid reservoir cap and area around cap.
2. Remove cap.
3. Fill the master cylinder reservoir with clean brake fluid.
4. Install Brake Bleeder Adapter J44894 (or equivalent) to the brake fluid reservoir.





5. Connect Pressure Bleeder J29532 (or equivalent) to adapter.
6. Charge pressure bleeder equipment to 138 - 172 kPa (20 - 25 psi).
7. Perform steps 2-6 of "Manual Bleeding" procedure skipping steps involving brake pedal operation.