Control Module: Service and Repair

TRANSAXLE CONTROL MODULE (TCM)

REMOVAL
1. Turn ignition OFF.





2. Pull retaining tang from the transaxle control module and rotate the transaxle control module up. Remove the transaxle control module from transaxle control module bracket.





3. Disconnect TCM J1 and J2 connectors.

INSTALLATION
1. Connect the transaxle control module J1 and J2 connectors.
2. Install the transaxle control module to the transaxle control module bracket.

IMPORTANT: DTC P0602 is set with all new service transaxle control modules. When the transaxle control module is reprogrammed with the correct software and calibrations, DTC P0602 will be erased.

3. Reprogram the transaxle control module with the correct calibration. Programming and Relearning