Ignition Lock Cylinder

REMOVAL

1. Disable SIR system. (Refer to "SIR Disable/Enable Procedure (For Frontal and Curtain Inflators)".
2. Disconnect negative battery cable.
3. Remove lock cylinder bezel from steering column shroud by carefully prying with thin blade screwdriver.




4. Remove shroud fasteners and remove steering column upper and lower shroud panels.
5. Insert key into ignition lock cylinder and rotate to RUN position. Then rotate ignition cylinder back to ACC position.




6. Depress locking button on side of ignition module assembly with a thin pick-type tool. Slide lock cylinder assembly from ignition module.

INSTALLATION

IMPORTANT: Actuator blade within ignition module housing must be in ACC position to install lock cylinder assembly. If rotated, replace it to ACC position, using needle nose pliers.




1. Insert key into ignition lock cylinder and install into ignition module.




2. Install steering column upper and lower shrouds and shroud fasteners.
3. Install lock cylinder bezel.
4. Connect negative battery cable.
5. Enable the SIR system. (Refer to "SIR Disable/Enable Procedure (For Frontal and Curtain Inflators)".