Input Speed Sensor (ISS)

INPUT SPEED SENSOR (ISS)

REMOVAL





1. Record preset radio stations.

CAUTION: DO NOT TIP BATTERY OVER 45° ANGLE OR ACID COULD SPILL.

2. Remove battery.
2.1. Remove battery cover.
2.2. Disconnect negative battery cable.
2.3. Disconnect positive battery cable.
2.4. Loosen battery hold-down screw and remove battery.





3. Remove battery cooling box.
4. Remove battery tray bracket.
4.1. Loosen battery tray bracket screws and remove bracket.
5. Disconnect wiring harness from input speed sensor.





6. Remove input speed sensor bolt and discard.
7. Remove input speed sensor.
8. Remove input speed sensor O-ring and discard.

INSTALLATION
1. Apply transaxle fluid to new O-ring.
2. Install new O-ring onto input speed sensor.
3. Install input speed sensor onto transaxle.
4. Install new input speed sensor bolt.
Torque: Input Speed Sensor Bolt: 6 N.m (53 inch lbs.)
5. Connect wiring harness to input speed sensor.





6. Install battery tray bracket.
6.1. Position battery tray bracket and tighten screws.
Torque: Battery Tray Bracket Screws: 16 N.m (12 ft. lbs.)
7. Install battery cooling box.





8. Install battery.
8.1. Insert battery and tighten battery hold-down screw.
Torque: Battery Hold-Down Screw: 15 N.m (11 ft. lbs.)
8.2. Connect positive battery cable to battery.
Torque: Battery Terminal Bolts: 17 N.m (13 ft. lbs.)
8.3. Connect negative battery cable to battery.
Torque: Battery Terminal Bolts: 17 N.m (13 ft. lbs.)
8.4. Install battery cooling box cover and tighten screws.
Torque: Battery Cooling Box Cover Screws: 2 N.m (18 inch lbs.)
8.5. Reprogram radio stations.