Drive Belt: Service and Repair

Drive Belt Replacement

^ Tools Required
- J 44811 Accessory Belt Tensioner Unloader

Removal Procedure

Caution: The tensioner assembly's internal parts are not serviceable. To avoid injury, do not disassemble the tensioner.





1. Disconnect the negative battery cable.
2. Raise the vehicle on the hoist.
3. Remove the right wheel and the splash shield.
4. Install the J 44811 onto the tensioner.
5. Remove the accessory drive belt.





Important: To remove the tensioner bolt an access hole has been provided through the inner and outer engine rail.

6. Remove the tensioner assembly.
7. Remove the tensioner bolt.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the tensioner assembly and bolt (if removed).
^ Tighten the drive belt tensioner bolt 45 Nm (33 ft. lbs.).
2. Route the belt around the alternator and the A/C compressor.





3. Install the J 44811 onto the tensioner and unload spring tension from the tensioner while positioning the belt.
4. Release the tensioner and remove the tool.
5. Install the right engine inner splash shield.
6. Install the right wheel and hand tighten the wheel nuts.
7. Lower the vehicle.
^ Tighten the wheel nuts 125 Nm (92 ft. lbs.).
8. Connect the negative battery cable
^ Tighten the battery terminal bolt 17 Nm (23 ft. lbs.).