Tie Rod: Service and Repair

Tie Rod End Replacement - Outer

^ Tools Required
- J 44015 Tie Rod Installer
- SA91 100C Tie Rod Separator

Removal Procedure





1. Raise and support the vehicle.
2. Remove the front tire assembly.

Important: Mark the location of the jam nut for installation.

3. Loosen the tie rod inner jam nut.





Important: Hold the ball stud to prevent turning during removal of the nut.

4. Remove the tie rod to knuckle nut. Discard the nut.





Notice: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.

5. Use the SA91 100C to separate the tie rod from the steering knuckle.





6. Remove the outer tie rod from the inner tie rod.

Installation Procedure





1. Install the outer tie rod to the inner tie rod.





2. Connect the tie rod to the knuckle.
3. Use the J 44015 to seat the ball stud taper to 40 Nm (30 ft. lbs.).
4. Remove the J 44015.





Notice: Refer to Fastener Notice in Cautions and Notices.

5. install a new tie rod retention nut.
^ Tighten the nut to 50 Nm (37 ft. lbs.).
6. Install the front tire assembly.
7. Check the wheel alignment.