7. Case Cover Assembly Removal

Case Cover Assembly Removal

- Tools Required
- J 43969 Case Cover Lifting Bracket
- J 44337 Build Plate Assembly






Notice: The control valve body assembly must be removed before removing the case cover assembly. Failure to follow this instruction may result in damage to the variable ratio control lever.

1. Remove the 2 bolts from the driven pulley cover.
2. Remove the 2 bolts from the drive pulley cover.





3. Remove the 14 case cover bolts.





4. Attach the shorter legs of the J 43969 to the two open bolt holes on the drive pulley cover.
5. Attach the longer legs of the J 43969 to the two open bolt holes on the driven pulley cover.






Important: There are two pry points on the case cover assembly.

Important: The seal between the case cover assembly and the transmission case assembly is tight.

6. Use a pry bar in order to separate the case cover assembly from the transmission case assembly.






Important: The J 43969 may require adjustment when lifting the case cover assembly.

7. Using a suitable lifting device, carefully remove the case cover assembly.





8. Lower the case cover assembly, with forward clutch and input shaft, into the J 44337 (2).
9. Remove the J 43969 (1).