P0112

DTC P0112

CIRCUIT DESCRIPTION




The DTC P0112 Intake Air Temperature (IAT) Sensor Circuit Low Voltage diagnostic monitors the signal circuit value. The IAT sensor is a variable resistor that measures the temperature of the intake air. The powertrain control module (PCM) supplies 5 volts to the IAT signal circuit and supplies a ground to the low reference circuit. If the PCM detects a low IAT signal voltage, which is a high temperature indication, this DTC sets.




The table illustrates the difference between temperature, resistance, and voltage.

DTC DESCRIPTOR
This diagnostic procedure supports the following DTC.
DTC P0112 Intake Air Temperature (IAT) Sensor 1 Circuit Low Voltage

CONDITIONS FOR RUNNING THE DTC
- The ignition is ON.
- DTC P0113 is not set.
- DTC P0112 runs continuously once the above conditions are met.

CONDITIONS FOR SETTING THE DTC
- The PCM detects that the intake air temperature (IAT) sensor signal voltage is 0.08 volts or less.
- The above condition is present for at least 5 seconds.

ACTION TAKEN WHEN THE DTC SETS
- The powertrain control module (PCM) illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
- The PCM records the operating conditions at the time the diagnostic fails. The PCM stores this information in the Freeze Frame/Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC
- The PCM turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A last test failed, or current DTC, clears when the diagnostic runs and does not fail.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Use a scan tool in order to clear the MIL and the DTC.

DIAGNOSTIC AIDS
- Use the Temperature vs Resistance table in order to test the IAT sensor at various temperature levels in order to evaluate the possibility of a skewed sensor. A skewed sensor could result in a driveability condition. If the engine has sat overnight, the engine coolant temperature and the intake air temperature values should display within a few degrees. If the temperatures are not within 3°C (5°F), refer to Temperature vs Resistance - Intake Air Temperature (IAT) Sensor.
- For an intermittent condition, refer to Intermittent Conditions. Intermittent Conditions

TEST DESCRIPTION

Steps 1-9:

The numbers below refer to the step numbers on the diagnostic table.
2. This step determines if a condition is present.
4. An intake air temperature below -30°C (-22°F) indicates the PCM and the IAT wiring are OK.
5. Disconnecting the PCM allows using the DMM in order to check continuity of the circuits. This aids in locating an open or a shorted circuit.
7. After replacing the PCM a new minimum throttle position and idle speed must also be established.