Multifunction, Turn Signal Switch Housing

Multifunction Turn Signal Switch Housing Replacement

Removal Procedure





1. Disconnect the negative battery cable.
2. Remove the SIR module..
3. Remove the steering wheel.
4. Remove the SIR coil.
5. Using a thin-bladed screwdriver, remove the lock cylinder bezel.
6. Remove the shroud fasteners.
7. Remove the upper and lower shrouds,





8. Depress the lock tabs on the left and right multi-function levers. Remove the multi-function levers.





9. Disconnect the housing electrical connectors.





10. Remove the lock housing bolts.
11. Separate the ignition housing from the multi-function lever bracket. Slide the bracket from the column.

Installation Procedure





1. Pre-assemble the lock housing and multi-function lever bracket. Hand-tighten the bolts, leaving approximately 3.2 mm (0.125 in.) gap at the bolt ends.

Important: Ensure that the lock tab fully engages into the column slot.

2. Slide the bracket onto the column.





3. Hand tighten the lower bolt until snug.
4. Hand tighten the upper bolt until snug.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Tighten the lower bolt.
^ Tighten the bolt to 8 Nm (71 in. lbs.)
6. Tighten the upper bolt.
^ Tighten the bolt to 8 Nm (71 in. lbs.)





7. Connect the ignition housing electrical connectors.





8. Install the multi-function levers.

Important: Ensure that both locking tabs are seated.





9. Install the upper and lower shrouds.
^ Tighten the shroud screws to 4 Nm (35 in. lbs.)
10. Install the lock cylinder bezel.
11. Install the SIR coil.
12. Install the steering wheel.
13. Install the SIR module.
14. Connect the negative battery cable.