119. Wiring Harness Installation

Wiring Harness Installation





1. Install an automatic transmission wiring harness O-ring seal (3) on the automatic transmission wiring harness (2) and route the wiring harness through the transmission case housing bore.





2. Connect the green wire harness connector (3) to the shift solenoid valve 3 (470).
3. Connect the yellow wire harness connector (4) to the TCC solenoid valve (468).
4. Connect the red wire harness connector (5) to shift solenoid valve 1 (466).
5. Connect the orange wire harness connector (6) to shift solenoid valve 2 (465).






Notice: Refer to Fastener Notice in Cautions and Notices.

6. Secure the transmission wiring harness assembly (2) with a M6 x 1.0 x 20 mm flanged bolt/screw (1) and tighten.
- Tighten the bolt/screw to 12 Nm (106 inch lbs.).