93. Torque Conv Housing, T/Case Input Shaft Fluid Seal Replacement

Torque Converter Housing, Transfer Case Input Shaft Fluid Seal Replacement

- Tools Required
- DT 46417 Driver 45mm x 63mm x 78mm
- EN 46342 Driver Handle
- J 26941 Bushing and Bearing Remover - 3-4 in
- SA9133TAxle Seal Puller
- SA9133T-1 Axle Seal Puller Adapter

Removal





Using the SA9133T (1), SA9133T-1 (2) and J 26941 (3), remove the transfer case input shaft oil seal (1118) from the torque converter housing (150).

Installation





Using the 65mm side of DT 46417 (2) and EN 46342 (1) install a NEW 48mm x 65mm x 7.5mm transfer case input shaft oil seal (1118) into the torque converter housing (150) until the seal is flush with the housing surface.