License Plate Lamp: Service and Repair

LICENSE LAMP REPLACEMENT

REMOVAL PROCEDURE
1. Remove the lift gate interior trim panel.
2. Remove the rear wiper assembly.




3. Disconnect the license lamp electrical connector.
4. Remove the license lamp bezel to lift gate nuts.
5. Remove the license bezel housing from the vehicle.

INSTALLATION PROCEDURE




1. Position the license lamp bezel on the lift gate.
2. Install the license lamp bezel to lift gate nuts.

NOTE: Refer to Fastener Note in Service Precautions.

Tighten the nuts to 4 N.m (35 lb in).

3. Connect the license lamp electrical connector.
4. Install the rear wiper assembly.
5. Install the lift gate interior trim panel.