Variable Drive Cover Replacement
Variable Drive Cover ReplacementRemoval Procedure
1. Remove the bolts from the drive pulley cover.
2. Remove the drive pulley cover.
3. Remove the variable drive pulley opening cover seal, outer, and discard.
4. Remove the variable drive pulley opening cover seal and discard.
Installation Procedure
1. Inspect the case cover seal on the drive pulley cover for damage. Replace if necessary.
2. Install a new variable drive pulley opening cover seal.
3. Install a new variable drive pulley opening cover seal, outer.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the drive pulley cover and bolts to the case cover assembly.
- Tighten the bolts to 11 Nm (97 inch lbs.).