Variable Driven Cover Replacement
Variable Driven Cover ReplacementRemoval Procedure
1. Install the engine support fixture.
2. Remove the transmission mount to the transmission bolts.
3. Remove the variable driven cover bolts.
4. Remove the variable driven cover from the transmission.
5. Remove the outer variable driven cover seal from the transmission and discard.
6. Remove the variable driven cover seals and discard.
7. Inspect the variable driven cover and cover seal for damage and replace as necessary.
Installation Procedure
1. Install two new variable driven cover seals.
2. Install a new outer variable driven cover seal.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the variable driven cover to the transmission.
- Tighten the variable driven cover bolts to 11 Nm (97 inch lbs.).
4. Install the transmission mount to the transmission bolts.
5. Remove the engine support fixture.