P0157
DTC P0157CIRCUIT DESCRIPTION
The secondary heated oxygen sensor (HO2S) measures the oxygen content of the exhaust downstream of the three-way catalyst (TWC), so that the TWC efficiency is optimized. The powertrain control module (PCM) supplies a voltage near 450 mVbetween the HO2S signal circuit and the low reference circuit. The HO2S varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean.
The PCM monitors and stores the HO2S voltage information. The PCM evaluates the HO2S voltage samples in order to determine the amount of time that the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period and determines if the majority of the samples are out of the operating range.
The PCM monitors the HO2S voltage for being fixed below a predetermined voltage. If the PCM detects the voltage is too low, this DTC sets.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTCs.
- DTC P0137 HO2S Circuit Low Voltage Bank 1 Sensor 2
- DTC P0157 HO2S Circuit Low Voltage Bank 2 Sensor 2
CONDITIONS FOR RUNNING THE DTC
- DTCs P0030, P0050, P0107, P0108, P0112, P0113, P0117, P0118, P0133, P0135, P0138, P0141, P0153, P0155, P0158, P0161, P0171, P0172, P0174, P0175, P0300, P0301-P0306, P0335, P0401, P0404, P0442, P0443, P0496, P1128, P1129, P2413, P2414, and P2415 are not set.
- The engine is operating for more than 2 minutes.
- The engine speed is less than 2,350 RPM.
- The engine coolant temperature (ECT) is more than 69°C (156°F).
- The intake air temperature (IAT) is more than -18°C (0°F).
- The HO2S 1 same bank lambda is between 0.73-1.47.
- The fuel system is in closed loop.
- DTCs P0137 and P0157 run once per drive cycle when the above conditions are met.
CONDITIONS FOR SETTING THE DTC
- The PCM detects that the affected HO2S 2 signal voltage is less than 290 mV.
- The condition exists for less than 30 seconds.
ACTION TAKEN WHEN THE DTC SETS
- The PCM illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic run and fails.
- The PCM records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the PCM stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the PCM records the operating conditions at the time of the failure. The PCM writes the conditions to the Freeze Frame and updates the Failure Records.
CONDITIONS FOR CLEARING THE MIL/DTC
- The PCM turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A last test failed, or current DTC, clears when the diagnostic runs and does not fail.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Use a scan tool in order to clear the MIL and the DTC.
TEST
