P0717

DTC P0717

Circuit Description
The automatic transmission input shaft speed (AT ISS) sensor is a three-wire magnetic pick-up sensor that is mounted externally to the transmission. The AT ISS utilizes the main idler gear teeth, located on the mainshaft, to generate a voltage signal of varying frequency that corresponds to the rotational speed of the automatic transmission output speed shaft (AT OSS) sensor. The AT ISS signal is sent to the powertrain control module (PCM) and is used to calculate the vehicle speed. Simultaneously, the signal from the AT OSS is used to calculate the vehicle speed. The PCM compares the vehicle speed calculated from both speed sensors and uses this comparison for diagnosis of the speed sensors. If the PCM detects a low AT ISS speed and a high AT OSS calculated vehicle speed for 10 seconds, DTC P0717 sets. DTC P0717 is a type A DTC.

Conditions for Running the DTC
- No VSS DTCs P0501 or P0502.
- No TR Switch DTCs P0705 or P0706.
- No ISS DTC P0717.
- No Clutch PC Solenoid 1 DTCs P0962 or P0963.
- No Clutch PC Solenoid 2 DTCs P0966 or P0967.
- No SS 1 DTCs P0973 or P0974.
- No SS 2 DTCs P0976 or P0977.
- No SS 3 DTCs P0979 or P0980.
- No TCC PC Solenoid DTCs P2763 or P2764.
- No TCC Enable Solenoid DTCs P2769 or P2770.
- The system voltage is 11 volts or greater.
- The vehicle speed is 13 mph (20 km/h) or greater.
- The transmission is not shifting.

Conditions for Setting the DTC:
The vehicle speed calculated from the AT OSS is 20 km/h (112 mph) or greater, while the vehicle speed calculated from the AT ISS is 2 km/h (11 mph) or less, for 10 seconds or greater.

Action Taken When the DTC Sets
- The PCM illuminates the malfunction indicator lamp (MIL).
- The PCM limits the transmission shift to 2nd and 3rd gears.
- The PCM records the operating conditions when the Conditions for Setting the DTC are met. The PCM stores this information as Freeze Frame and Failure Records.
- The PCM stores DTC P0717 in PCM history.

Conditions for Clearing the MIL/DTC
- The PCM turns OFF the MIL during the third consecutive trip in which the diagnostic test runs and passes.
- A scan tool can clear the MIL/DTC.
- The PCM clears the DTC from PCM history if the vehicle completes 40 warm-up cycles without an emission related diagnostic fault occurring.

Diagnostic Aids
- Inspect the connectors at the PCM, the AT ISS, and all other circuit connecting points for an intermittent condition.
- Inspect the circuit wiring for an intermittent condition.
- Inspect for a disconnected AT ISS connector.
- Inspect for an open or shorted AT ISS wire.
- Inspect for a faulty AT ISS.
- Inspect for an internal fault of the PCM.

Steps 1 - 6:

Steps 7 - 13:

DTC P0717