P2112

DTC P2112

DESCRIPTION




This DTC detects a faulty throttle valve position. The throttle valve in the throttle body utilizes a throttle return spring to assist in positioning the throttle valve at a resting or default position. The powertrain control module (PCM) uses driver input from the accelerator pedal position (APP) sensor in order to calculate the desired throttle position. The PCM sends the desired throttle position or target value to the TAC module. The TAC module achieves the desired throttle position by commanding the throttle control motor to position the throttle valve at the target value. The TAC module then compares the TP sensor 1 value to the target value. If necessary, the throttle control motor is moved slightly in order to obtain the exact target value position. If the TP sensor indicates that the throttle valve has failed to reach the default position a DTC P2112 sets. For additional information on the operation of the TAC system refer to Throttle Actuator Control (TAC) System Description.

DTC DESCRIPTOR
This diagnostic procedure supports the following DTC.
DTC P2112 Throttle Actuator Control (TAC) Throttle Valve Stuck Closed

CONDITIONS FOR RUNNING THE DTC
- DTCs P0117, P0118, P0122, P0123, P0222, P0223, P0641, P0651, P2100, P2101, P2108, P2122, P2123, P2127, P2128, P2135, P2138, P2176, or U0107 are not set.
- The engine coolant temperature (ECT) is more than 70°C (158°F).
- The ignition is ON, with the engine OFF.
- DTC P2112 runs once per drive cycle when the above conditions are met.

CONDITIONS FOR SETTING THE DTC
The throttle position (TP) is not between 4.9-7.9 degrees or less when the throttle valve is expected to be at the default position.

ACTION TAKEN WHEN THE DTC SETS
- The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame/Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.

DIAGNOSTIC AIDS
- Use the J-35616 Connector Test Adapter Kit for any test that requires probing the PCM harness connector or a component harness connector.
- Inspect for a condition in which the throttle valve may have been held open. For example, ice may have formed in the throttle bore causing the throttle valve not to close. Observe the Freeze Frame/Failure Records.
- The throttle valve is spring loaded to a slightly open position. The throttle valve should be open approximately 11-15 percent. This is referred to as the rest position.
- The throttle valve should not be completely closed or open any more than a specified amount.
- The throttle valve should move open and to the closed position without binding under the normal spring pressure.
- The throttle should NOT be free to move open or closed WITHOUT spring pressure.
- The scan tool has the ability to operate the throttle control system using the throttle actuator control located in the throttle control menu. This function operates the throttle valve through the entire range in order to determine if the throttle actuator control (TAC) system operates correctly. Additional DTCs may set using this function. Refer to Scan Tool Output Controls for more information. Scan Tool Output Controls
- For an intermittent condition, refer to Intermittent Conditions. Intermittent Conditions

TEST DESCRIPTION

Steps 1-9:

Step 10:

The numbers below refer to the step numbers on the diagnostic table.
2. This step determines if the condition exists.
5. Coking on the throttle bore or valve may cause this DTC to set.
6. This step determines if the coking was the cause of the DTC.