Trunk / Liftgate: Adjustments

Lift Gate Adjustment





1. Note the original position of the lift-gate latch striker.
2. Remove the striker.
3. Loosen the hinge-to-roof panel bolts for forward or rearward adjustments.
4. Loosen the lift gate-to-hinge bolts for up and down adjustment.
5. Move the lift gate within the lift gate opening to achieve the best alignment and operation.
6. Install striker to approximately the proper position.
7. Adjust the striker to achieve the best operation and alignment of the lift gate.
8. Check the seals for proper engagement.

Notice: Refer to Fastener Notice in Cautions and Notices.

9. Tighten the bolts when the proper adjustment is achieved.

Tighten the bolts to 25 N.m (18 lb ft).