75. Camshaft Installation - Right

Camshaft Installation - Right

^ Tools Required
- EN 46334 Camshaft Oil Seal Driver
- EN 46337 Camshaft Sprocket/Crankshaft Balancer Holder





1. Lubricate the camshaft journals and bores with clean engine oil.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the camshaft (209), NEW O-ring (210), cap (211) and bolts (212).
^ Tighten the bolts to 22 Nm (16 ft. lbs.).





3. Use the EN 46334 in order to install the seal (223) into the cylinder head. Rotate the bolt clockwise until the tool bottoms in the cylinder head bore.





4. Install the cover (246), NEW seal (245) and bolts (247).
^ Tighten the bolts to 22 Nm (16 ft. lbs.).
5. Install the sprocket (248) and bolt (249).





6. Use the EN 46337to retain the camshaft sprocket.
^ Tighten the bolt to 90 Nm (67 ft. lbs.).





7. Rotate the camshaft to align the mark on the sprocket (2) with the pointer on the rear cover (1).