Output Speed Sensor Replacement

Output Speed Sensor Replacement

Removal Procedure





1. Raise and support the vehicle.
2. Disconnect the wiring harness from the output speed sensor.

Important: Do not damage the output speed sensor or transaxle case.

3. Remove the output speed sensor bolt/screw.
4. Remove the output shaft speed sensor and the O-ring.

Installation Procedure





1. Apply automatic transmission fluid to the new output speed sensor O-ring seal.
2. Install the new output speed sensor O-ring seal onto the output speed sensor.
3. Install the output speed sensor into the transmission case assembly.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the output speed sensor bolt.
- Tighten the output speed sensor bolt to 12 Nm (87 inch lbs.).
5. Connect the wiring harness to the output speed sensor.
6. Lower the vehicle.