15. Shaft and Clutches Removal

Shaft and Clutches Removal






Caution: This procedure requires 3 technicians. Each technician needs to remove or install a complete shaft assembly in order to prevent personal injury.

1. Bend the lock tab of the reverse shift fork lock washer (925) on the reverse shift fork (924).
2. Remove the reverse shift fork retainer bolt (926) and lock washer (925) from the reverse shift fork (924).






Notice: Do not allow the reverse shift fork to fall on the floor during the removal of the 3 shaft assemblies. The reverse shift fork will fall free from the output shaft assembly, possibly damaging the fork end of the shaft.

3. As a complete assembly, lift straight up the mainshaft assembly (640), the output shaft assembly (535) and 1st /2nd clutch shaft assembly (755) until they are clear of from the torque converter housing assembly (150) as shown.
4. Remove the 2nd clutch housing thrust washer (750) from the torque converter housing (150).