34. 3RD Clutch Shaft Transmission Case Bearing Replacement

3rd Clutch Shaft Transmission Case Bearing Replacement

- Tools Required
- DT 46424 Adjustable Bearing Remover
- EN 46342 Driver Handle
- DT46516 Driver
- SA9133TAxle Seal Puller
- SA9133T-1 Axle Seal Puller Adapter

Removal





1. Using the DT 46424 (1), SA9133T (2) and SA9133T-1 (3), remove the 3rd clutch shaft transmission case bearing (65) from the transmission case housing.
2. Inspect the bearing for wear or damage. Replace as needed.

Installation





Using the 42 mm side of DT 46516 (2) and EN 46342 (1), install the 20 mm x 41 mm x 17/16 mm 3rd clutch shaft transmission case bearing (65) until it bottoms out flush in the transmission case housing.