Engine Support Fixture

Engine Support Fixture

^ Tools Required
- J 28467-34 Lift Hook Wing Nut and Washer (2)
- J 28467-6A Bracket Assembly (2)
- J 28467-7A Bolt Hook (2)
- J 28467-500 Engine Support Fixture
- J 28467-B Universal Engine Support Fixture
- J 45057 Engine Support Bar Assembly
- J 45057-2 Lower Support Bar

Installation Procedure
1. Remove the right engine mount strut.





2. Install the J 45057 to the right engine mount strut bracket (1).





3. Install the J 45057 to the left side engine lift bracket.





4. Install the J 45057 to the right rear engine lift bracket.
5. Disconnect the hood strut assist rods from the fenders.
6. Carefully open and secure the hood in a 90 degree position.





7. Install a J 28467-B and retention pin to each end of the J 28467-500 beam (2).





8. Position the J 28467-B to the left and right side inner fender rails in order to install the J 28467-500.





9. Assemble the following to create 2 lift hook assemblies as shown:
^ J 28467-34
^ J 28467-6A
^ J 28467-7A





10. Install the 2 lift hook assemblies (1) to the J 45057-2 (2).





11. Install the right side lift hook assembly to the right side hole in the J 45057 (2).





12. Install the left side lift hook assembly to the left side hole in the J 45057 (2).
13. Gently tighten the J 28467-34 lift hook wing nuts.
14. Raise the vehicle. Refer to Vehicle Lifting.
15. Remove the lower air baffle.
16. Remove the engine mount left bolt.





17. Install the J 45057-2 to the radiator core support.
18. Use the engine mount bolt to install the J 45057-2 to the engine.





19. Ensure that the J 45057-2 is assembled properly and hand tighten the fasteners.