Catalytic Converter: Service and Repair

Catalytic Converter Replacement

Removal Procedure
Replace the entire converter assembly in order to properly service the 3-way catalytic converter.





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the heated oxygen sensor connector.
3. Remove the exhaust manifold pipe nuts from the exhaust manifold pipe studs.





4. Remove the catalytic converter nuts from the exhaust pipe.
5. Remove the 3-way catalytic converter.

Installation Procedure





1. Notice: To prevent internal damage to the flexible coupling of the catalytic converter assembly, the converter must be supported. The vertical movement at the rear of the catalytic converter assembly must not exceed 6 degrees up or down.

Install a new catalytic converter gasket.
2. Install a new exhaust manifold pipe gasket.
3. Position and support the new 3-way catalytic converter under the vehicle.
4. Install the exhaust pipe to the 3-way catalytic converter with the catalytic converter nuts. Do not tighten the nuts.





5. Notice: Refer to Fastener Notice in Service Precautions.

Install the exhaust manifold pipe nuts to the exhaust manifold pipe studs.
^ Tighten the exhaust manifold pipe nuts to the exhaust manifold pipe stud to 35 Nm (26 ft. lbs.).
^ Tighten the catalytic converter nuts to 34 Nm (25 ft. lbs.).
6. Connect the heated oxygen sensor connector.
7. Lower the vehicle.