Compressor/Pump Relay: Service and Repair

Automatic Level Control Relay Replacement

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.





2. Remove mounting screw (1) from the automatic level control relay.





3. Remove electrical connector (1) from the automatic level control relay (2).

Installation Procedure





1. Install electrical connector (1) into the automatic level control relay (2).





Notice: Refer to Fastener Notice in Service Precautions.

2. Install mounting screw (1) into the automatic level control relay.
^ Tighten screw to 6 Nm (53 inch lbs.).
3. Lower the vehicle.