Transmission Replacement (M15)

Transmission Replacement (M15)

^ Tools Required
- J 35944-A Transmission Oil Cooler and Line Flusher
- J 37096 Flywheel Holder

Removal Procedure





1. Remove the push pins from the coolant recovery bottle.
2. Position aside coolant recovery bottle.
3. Remove air cleaner assembly.





4. Remove the automatic transmission range selector cable (1) from the manual shaft (5).
5. Remove the automatic transmission range selector cable bracket (4).





6. Disconnect the wiring harness connector (3) from the transaxle.
7. Remove the wiring harness retainer from the side cover.





8. Remove the top four bell housing bolts (1, 2, 3) and stud (4).
9. Install the engine support fixture.
10. Remove the frame.





11. Remove the torque converter inspection cover.





12. Use J 37096 in order to gain access to the torque converter bolts and prevent the flywheel from turning.





13. Remove the torque converter bolts.
14. Disconnect the vehicle speed sensor.
15. Remove the right and left axle shafts from the transmission.
16. Disconnect the transmission cooler lines.
17. Position the transmission jack under the transaxle.
18. Remove the transaxle brace.





19. Remove the lower transaxle bolt (6) and stud (5).
20. Remove the transaxle from the vehicle.

21. Important: Use J 35944-A or equivalent to flush the following components whenever the transaxle is removed for overhaul or whenever the torque converter pump or the case is replaced:

Flush the transaxle oil cooler pipes and the transaxle oil cooler.
22. Transfer all necessary parts as needed.

Installation Procedure
1. Align the transaxle filler tube to the transmission and Install the transaxle into the vehicle.





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the lower transaxle bolt (6) and stud (5).
^ Tighten the bolt and stud to 75 Nm (55 ft. lbs.).
3. Install the transaxle brace.
4. Install the transaxle brace.
5. Connect the transmission cooler lines.
6. Install the right and left axle shafts into the transaxle.
7. Connect the vehicle speed sensor.





8. Install the torque converter bolts.
^ Tighten the bolts to 63 Nm (46 ft. lbs.).





9. Install the torque converter inspection cover.
10. Install the frame.
11. Install the front wheels.
12. Lower vehicle.
13. Remove the engine support fixture.





14. Install the upper transaxle bolts (1, 2, 3) and stud (4).
^ Tighten the bolts and stud to 75 Nm (55 ft. lbs.).





15. Connect the wiring harness (3) to the transaxle.





16. Install the transmission range selector cable bracket (4).
17. Install the automatic transmission range selector cable (1) on the manual shaft (5).
18. Install the air cleaner assembly.





19. Install the coolant recovery bottle.

Notice: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.

20. Adjust the fluid level.
21. Inspect for fluid leaks.