Instrument Panel (IP) - Tie Bar / Cross Vehicle Beam
Instrument Panel Tie Bar ReplacementREMOVAL PROCEDURE
CAUTION: Refer to Approved Equipment for Collision Repair Caution in Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
2. Remove all related panels and components.
3. Repair as much of the damage as possible to factory specifications.
4. Remove the damaged I/P tie bar.
INSTALLATION PROCEDURE
1. Position the I/P tie bar to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts that hold the I/P tie bar to the hinge pillar inner.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
3. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.