Seat Back Latch Release Cable Replacement - Rear

Seat Back Latch Release Cable Replacement - Rear

Removal Procedure





1. Remove the fastener from the rear seat back latch and pull the latch out from the seat back assembly.




2. Detach the latch cable from the latch.




3. If you are going to replace the cable, disconnect the latch cable at the seat recliner mechanism.




4. Open the J-strip at the bottom of the seat cover.




5. Pull the cable out from the seat back assembly.



Installation Procedure





1. If you are replacing the cable, route the cable through the rear seat back.




2. Connect the latch cable to the recliner mechanism.




3. Connect the J-strip at the bottom of the seat cover.
4. Connect the latch cable to the latch assembly.





Notice: Refer to Fastener Notice in Cautions and Notices.

5. Install the latch to the seat back with a fastener.

Tighten the fastener to 2.5 N.m (22 lb in).