Ignition Switch

Ignition Switch Replacement
Removal Procedure
1. Remove the SIR module.
2. Remove the steering wheel.
3. Remove the SIR coil.
4. Using a thin-bladed screwdriver, remove the lock cylinder bezel.





5. Remove the shroud fasteners.
6. Remove the upper and lower shrouds.





7. Depress the lock tabs on the left and right multi-function levers. Remove the multi-function levers.





8. Disconnect the electrical housing electrical connectors.





9. Disengage the retaining tabs on the park lock cable assembly. Remove the assembly from the ignition module.





10. Remove the lock housing bolts.
11. Turn the ignition key to the ACC position





12. Separate the ignition housing from the multi-function bracket.
13. Remove the ignition switch screws
14. Remove the ignition switch.

Installation Procedure





1. Ensure that the ignition switch is in the ACC position.

2. Notice: Position the ignition switch to the housing. Tighten the screws until seated.

Tighten the ignition screws to 2.5 Nm (22 inch lbs.).
3. Pre-assemble the lock housing and multi-function lever bracket. Hand-tighten the bolts, leaving approximately 3.2 mm (0.125 inch) gap at the bolt ends.

Important: Ensure that the lock tab fully engages into the column slot.

4. Slide the bracket onto the column.





5. Hand tighten the lower bolt until snug.
6. Hand tighten the upper bolt until snug.
7. Tighten the lower bolt.
^ Tighten the bolt to 8 Nm (71 inch lbs.)
8. Tighten the upper bolt.
^ Tighten the bolt to 8 Nm (71 inch lbs.)





9. Snap the ignition lock cable onto the ignition module.
10. Connect the ignition switch electrical connector





11. Connect the ignition housing electrical connectors.





12. Install the multi-function levers.

Important: Ensure that both locking tabs are seated.





13. Install the upper and lower shrouds.
^ Tighten the shroud screws to 4 Nm (35 inch lbs.)
14. Install the lock cylinder bezel.
15. Install the SIR coil.
16. Install the steering wheel.
17. Install the SIR module.