Ignition Lock Cylinder

Ignition Lock Cylinder Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Disable the SIR system. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
3. Remove the steering column trim covers.





4. Insert key into the ignition and rotate to the RUN position. Then rotate ignition cylinder back to ACC position.





5. Depress the locking button through hole on side of ignition module assembly with a thin pick-type tool. Slide the lock cylinder from the ignition housing.

Installation Procedure





Important: Actuator blade within the ignition module must be in ACC position to install the lock cylinder assembly. If rotated, reposition the actuator blade to the ACC position using needle nose pliers.





1. Important: If you are installing a new lock cylinder,

Insert key into ignition lock cylinder and install the cylinder into the lock housing.
2. Rotate the lock cylinder in the housing. Verify proper rotation.
3. Install the steering column trim covers.
4. Enable the SIR system. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
5. Connect the negative battery cable.