Multifunction, Turn Signal Switch Housing

Multifunction Turn Signal Switch Housing Replacement
Removal Procedure





1. Disconnect the negative battery cable.
2. Disable the SIR system. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
3. Remove the steering wheel.
4. Remove the SIR coil.
5. Remove the steering column trim covers.
6. Depress the lock tabs on the left and right multifunction levers. Remove the multifunction levers.





7. Disconnect the housing electrical connectors.





8. Remove the lock housing bolts.
9. Separate the ignition housing from the multifunction lever bracket. Slide the bracket from the column.

Installation Procedure





1. Pre-assemble the lock housing and multifunction lever bracket. Hand-tighten the bolts, leaving approximately 3.2 mm (0.125 inch) gap at the bolt ends.

2. Important: Ensure that the lock tab fully engages into the column slot.

Slide the bracket onto the column.
3. Hand-tighten the lower bolt until snug.
4. Hand-tighten the upper bolt until snug.

5. Notice: Tighten the lower bolt.

Tighten the bolt to 8 Nm (71 inch lbs.)
6. Tighten the upper bolt.
^ Tighten the bolt to 8 Nm (71 inch lbs.)





7. Connect the ignition housing electrical connectors.





8. Important: Ensure that both locking tabs are seated.

Install the multifunction levers.
9. Install the upper and lower shrouds.
10. Install the SIR coil.
11. Install the steering wheel.
12. Enable the SIR system. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
13. Connect the negative battery cable.