16. Wiring Harness Installation

Wiring Harness Installation





1. Install an automatic transmission wiring harness O-ring seal (3) on the automatic transmission wiring harness (2) and route the wiring harness through the transmission case housing bore.





2. Connect the green wire harness connector to the B shift solenoid valve (470).
3. Connect the yellow wire harness connector to the TCC solenoid valve (468).
4. Connect the red wire harness connector to the A shift solenoid valve (466).
5. Connect the orange wire harness connector to the C shift solenoid valve (465).





6. Notice: Refer to Fastener Notice in Service Precautions.

Install the transmission wiring harness assembly (2).
7. Install the transmission wiring harness M6 x 1.0 x 20 mm bolt (1).
^ Tighten the bolt to 12 Nm (106 inch lbs.).