Rear Side Door Window Replacement

Window Replacement - Rear Door

Removal Procedure





1. Remove the rear door outer belt seal. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer (Rear Door Window Belt Outer Sealing Strip Replacement) .
2. Remove the inner rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair
3. Remove the rear door water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
4. Remove the rear door lower speaker to access the forward edge of the glass. Refer to Speaker Replacement - Rear Door in Entertainment.
5. Lower window to access window bolts.
6. Remove the window bolts.
7. Pull the window out of the window regulator guide plate.
8. Slide the window down and out of the primary glass run channels.
9. Remove the window by tilting outboard and pulling the window out of the door through the door belt opening.



Installation Procedure





1. Install the window glass by sliding the window into the door through the outside door belt opening.
2. Install the window into the primary glass run channels and rest the window on the regulator guide plate.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the window bolts.

Tighten the bolts to 10 N.m (89 lb in).

4. Install the rear door lower speaker. Refer to Speaker Replacement - Rear Door in Entertainment.
5. Install the rear door water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
6. Install the rear inner door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair
7. Install the rear door outer belt seal. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer (Rear Door Window Belt Outer Sealing Strip Replacement) .
8. Operate the window to inspect the operation.