Blower Case Assembly

BLOWER CASE ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE
1. Remove the evaporator core.
2. Remove the air inlet assembly.
3. Remove the HVAC module wire harness from the blower case assembly.




4. Remove the blower motor screws from the blower case assembly.
5. Remove the blower motor from the blower case assembly.




6. Remove the blower motor resistor screws from the blower case assembly.
7. Remove the blower motor resistor from the blower case assembly.

INSTALLATION PROCEDURE




1. Install the blower motor resistor to the blower case assembly.
2. Install the blower motor resistor screws to the blower case assembly.

Tighten the screws to 1 N.m (9 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the blower motor to the blower case assembly.
4. Install the blower motor screws to the blower case assembly.

Tighten the screws to 1 N.m (9 lb in).

5. Install the HVAC module wire harness from the blower case assembly.
6. Install the air inlet assembly.
7. Install the evaporator core.