Instrument Panel Cluster (IPC) - Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
2. Place the steering column in the lowest position.
3. Remove the I/P cluster trim plate.




4. Remove the fasteners from the upper and the lower cluster. Pull rearward to remove the I/P cluster.
5. Disconnect the I/P cluster harness.

INSTALLATION PROCEDURE




1. Connect the I/P cluster harness.
2. Install the I/P cluster in the I/P housing. Install and tighten the fasteners.

NOTE: Refer to Fastener Note in Service Precautions.

Tighten the fasteners to 2 N.m (18 lb in).

3. Install the I/P cluster trim plate.
4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3.