17. Clutch Pressure Control Solenoid Manifold Installation

Clutch Pressure Control Solenoid Manifold Installation





1. Install two 8 x 14 mm clutch pressure control (CPC) solenoid manifold locating pins (83) into the transmission case (31).
2. Install the CPC solenoid manifold gasket (82).





3. Notice: Refer to Fastener Notice in Service Precautions.

Install the CPC solenoid manifold (84). Install the seven M6 x 1.0 x 35 mm CPC solenoid manifold bolts (85).
^ Tighten the bolts to 12 Nm (106 inch lbs.) in the sequence shown.