18. Clutch Pressure Control Solenoid Installation

Clutch Pressure Control Solenoid Installation





1. Important: Install the fluid feed pipes with the filter side of the pipe into the transmission case as shown in insert.

Install a 8 x 105.8 mm clutch pressure control (CPC) solenoid fluid pipe (14) into the transmission case (31).
2. Install 2 8 x 58.3 mm CPC solenoid fluid pipes (15), (19) into the transmission case (31).





3. Install the new CPC solenoid gasket (20) to the clutch pressure control solenoid manifold (84).

4. Important: Do not damage the O-ring seals (9) during installation.

Install a 7.7 x 2.3 mm fluid pipe O-ring seal (9) over each of the 3 fluid passage pipes.





5. Install the CPC solenoid valve assembly (18) onto the solenoid cover (84).
6. Install the following CPC solenoid valve bolts:
^ 5 M6 x 1.0 x 25 mm bolts (17)
^ A M6 x 1.0 x 55 mm bolt (16)





7. Notice: Refer to Fastener Notice in Service Precautions.

Tighten the bolts in the sequence shown.
^ Tighten the bolts to 12 Nm (106 inch lbs.).