2. Servo Valve Body Assembly Installation

Servo Valve Body Assembly Installation





1. Install the transmission fluid filter (211) into the control valve body assembly (250).
2. Install both 8 x 14 mm spacer plate locating pins (301) into the control valve body assembly (250).
3. Install the servo valve body spacer plate (300) on top of the control valve body assembly (250).
4. Install the servo valve body assembly (325) on top of the control valve body assembly (250).





5. Notice: Refer to Fastener Notice in Service Precautions.

Install the servo valve body M6 x 1.0 x 60 mm bolt (312).
^ Tighten the bolt to 12 Nm (106 inch lbs.)





6. Install the 1st clutch accumulator 7/32 in check valve (311) into the servo valve body assembly (325).
7. Install the 1st clutch 7/32 in check valve (318).
8. Install the 2nd clutch 7/32 in check valve (319).
9. Install the 1st accumulator choke (326).